Backhoe Contribution-spikeyxxx-Wheels/Axle

Didn’t start this earlier, because there was not much to show; I must have started from scratch on the front axle, about 17 times!

This was because I couldn’t ‘understand the shape of it…(Still need to figure out how the steering is connected to the axle…)

I submitted this yesterday, because it was time and I am not unhappy with where this is going:

There are however some intersections with the Chassis @adrian2301 and the axle should actually be able to rotate quite a bit on the Y-axis and there doesn’t seem to be a lot of wriggle room there:

Although it has room on one side, so maybe that is ok, have to re-watch that video that @blanchsb linked me to…

The engine enclosure however @artifact and @doulos4iesou  is completely in the way;)

My bad, it should be right in the center, it wouldn’t make any sense to  me for it to be off-centered.

I’ll fix that right away, thanks.

@adrian2301 this updated version already looks a lot better:

@blanchsb Thanks, you can check it out at the Google sheet for the Collaboration. You can read all the Comment boxes (where there is a little orange triangle in the upper right corner) and thus have access to all contributions…

There are still a few tiny mistakes in that (second) file, they have already been fixed now, but I didn’t want to update my submission again (there were some non-quads, because some verts hadn’t merged at some point…and one ‘ugly’ quad, I mean shaped like an arrow head.).