shwang

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
July 8, 2020 at 12:06 pm in reply to: Why does the decorative curl from my bezier curve have an uneven thickness (thick at one end, decreasing to very thin on the other)? #58626
shwang
Participant
Thanks, guys, for your help! Your advice did the trick! 😀
July 7, 2020 at 7:40 pm in reply to: Why does the decorative curl from my bezier curve have an uneven thickness (thick at one end, decreasing to very thin on the other)? #58623
shwang
Participant
Thank you – I’m relatively new to Blender so the support is very much appreciated!! The file link on Google Drive is (I hope this works):

https://drive.google.com/file/d/1t5EG4U5NGL7FIgx9WffZg7DxiHKxdQF1/view?usp=sharing
July 6, 2020 at 8:09 am in reply to: Why does the decorative curl from my bezier curve have an uneven thickness (thick at one end, decreasing to very thin on the other)? #58620
shwang
Participant
Hi – Unfortunately, that doesn’t seem to be it, because whether everything is put on the lattice or not, the curve still has the uneven thickness…
July 5, 2020 at 4:20 pm in reply to: Why does the decorative curl from my bezier curve have an uneven thickness (thick at one end, decreasing to very thin on the other)? #58618
shwang
Participant
This is the problem I have been having… I am unable to make the thickness of the curve uniform on the shield. If someone could help me pinpoint the issue, I would greatly appreciate it! Thank you!
July 5, 2020 at 4:19 pm in reply to: Why does the decorative curl from my bezier curve have an uneven thickness (thick at one end, decreasing to very thin on the other)? #58617
shwang
Participant
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)