[none none]

Got now more intuitive feeling, not yet able to full explain to someone else. But at least what I learned is that in the case of doing this small segment (that messed it up before), that *sometimes* it might better not to model the small edge, but can use a bevel modifier as well (with limit mode set to weight). Will take more experience to fully grasp it, but at least one step ahead. Thnx for your support

[none none]

Hi Thanks a lot Martin

To confirm my understanding: It would have been better if my bevel (for the teeth cut-outs), would have had one or 2 vertexes less, as then they would have been spaced out more?

In other words, the problem is regardless the scale (apply scale was done). I would have had the same issue if I would have made a console much bigger? (instead of e.g dimension of 10 cm, made one of 10 meter big)

For my own learning, I will restart and do the tutorial, and first start with teeth mark and related bevels before doing anything else… So to play around, confirm and learn!

Regards

[Author]

Posts