[Bradly Bernhardt]

Thank you for your help! I think i am getting an understanding that these edges should not cross the bevel at the corner greater than or less than 45 degrees and is best to avoid doing so. 

[Bradly Bernhardt]

Though i have moved on in the lesson,  I made a separate version so I could play with it. I wanted to find a way to highlight the offending bezels but just running out of gas tonight.  https://drive.google.com/file/d/11utvYtuitga72YcY07C__NawQPkQ5fYB/view?usp=sharing

so the group on the bottom is applied bezel. I think from top view you can really see how the corner edges are not 45 degrees on the bottom left 2 group.

The one on the right is the winner (on the console too) at 45. the one in the middle is like in the video, and the one on the left is the M shaped one. i dont think any of them have a chance to have a double vertice because I was just selecting 2 edges and pressing f on the left and middle ones. Like I said, I have moved on but am interested on the method of connection and best practices when it comes to this.

[Bradly Bernhardt]

Well its hard to argue with so many people, but i think this might be the 1% in this case. Im very new to this so bear with me. so scale was already applied, and i applied it again for good measure. Their all 1.0’s. ok so ive been playing with how the face is cut up and if you do it this way, the wonkyness changes to the other bevel. the one on the end is now correct. And the one closes and on the left is wonky now.

kinda like an M. anyways, i think its those edges in the outer corners.

so this works. I dont know whats going on here, all i know is its been driving me nuts.

[Author]

Posts