Join Now

Why was my X- Axis an increasing function on Y rather than an decreasing function on Y as in the video?

Forum Archive › Why was my X- Axis an increasing function on Y rather than an decreasing function on Y as in the video?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 22, 2021 at 9:10 pm #13529
    Andy Grogan
    Participant

      Hey Wayne (or who every else might know the answer),

      I used the Arcing ball bounce start file labeled 2.8 and was following along with the exercise video except when it came to the function line for the x-axis mine was increasing on x & y rather than decreasing on x & y like in Wayne’s video. It seemed to look OK anyway but I don’t understand why my y increased rather than decreased. I am using Blender 2.91.2.

      Ciao

      February 23, 2021 at 5:51 pm #63047
      Wayne Dixon
      Participant

        Hi Agro,

        I think I corrected the orientation of the controls for the 2.8+ version of the rig so it would match world space.

        It works the same, but in the video, the local orientation of the bone thinks that down is up and up is down.

        Hope this makes sense.

        February 23, 2021 at 5:52 pm #63048
        Andy Grogan
        Participant

          Thanks, I guessed that might be the case.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘Why was my X- Axis an increasing function on Y rather than an decreasing function on Y as in the video?’ is closed to new replies.