Make a robot using extrude, subdivision and edge loops
- This topic has 1 reply, 2 voices, and was last updated 3 years, 8 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
In the Fundamentals course (at the end of the extrude lesson) we were asked to create a robot from a cube, using extrude, subdivision and edge loops.
It was a fun challenge and I set out to make a small critter using way to many edge loops, where I should have used subdivisions.
It was still a fun practice
Viewing 2 posts - 1 through 2 (of 2 total)
- The topic ‘Make a robot using extrude, subdivision and edge loops’ is closed to new replies.