Join Now

is there any reason you can think of that would cause an artifact to occur on only one side of the model, but not the other? even with all the work being symmetrical

Forum Archive › is there any reason you can think of that would cause an artifact to occur on only one side of the model, but not the other? even with all the work being symmetrical

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 23, 2017 at 3:21 pm #6453
    melted_media
    Participant
      September 28, 2017 at 8:45 am #25429
      Kent Trammell
      Participant

        It’s not uncommon for that to happen. Not sure why exactly, but my guess is that dynamic topology’s mesh generation isn’t 100% symmetrical. At which point you can use the “Symmetrize” button in sculpt mode’s tool panel (when sculpting with dynamic topology) to return to perfect symmetry.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • The topic ‘is there any reason you can think of that would cause an artifact to occur on only one side of the model, but not the other? even with all the work being symmetrical’ is closed to new replies.