I'm trying to figure how how to properly shorten the length of the bottom part of the cylindrical top of the cone object w…

This topic has 1 reply, 1 voice, and was last updated 9 years, 4 months ago by chadb704.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 10, 2017 at 12:04 pm #4111
chadb704
Participant
I’m trying to figure how how to properly shorten the length of the bottom part of the cylindrical top of the cone object while moving the upper part down accordingly. I can use extrude and just push it in, but that’s messy. I can also use scale, but that warps the top part without moving it down. I’m sure I’m missing something simple and obvious here.
May 10, 2017 at 2:06 pm #22018
chadb704
Participant
Scratch that, I figured it out. I just had to select everything above the part I wanted to shorten and move it down with the 3D manipulator.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘I'm trying to figure how how to properly shorten the length of the bottom part of the cylindrical top of the cone object w…’ is closed to new replies.