I am working on a model with a lot od process piping where I need a cylinder to turn in 90 degrees and extend out then tur…

This topic has 0 replies, 1 voice, and was last updated 11 years, 2 months ago by Boone Birdsell.

Viewing 1 post (of 1 total)

Author

Posts
July 5, 2015 at 8:49 pm #3854
Boone Birdsell
Participant
I am working on a model with a lot od process piping where I need a cylinder to turn in 90 degrees and extend out then turn again. I have not seen the method for doing this. What is the command?
Author

Posts

Viewing 1 post (of 1 total)

The topic ‘I am working on a model with a lot od process piping where I need a cylinder to turn in 90 degrees and extend out then tur…’ is closed to new replies.