I am using v2.78c. I have installed the addon from the link in the notes. I have read the comments below, but I still can …

This topic has 1 reply, 2 voices, and was last updated 8 years, 10 months ago by Kent Trammell.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
July 13, 2017 at 2:50 pm #5013
CJ Scott
Participant
I am using v2.78c. I have installed the addon from the link in the notes. I have read the comments below, but I still can not get the grease cut to work in any view. Any ideas? I don’t want to install an old version because I’ll be learning techniques that wont apply in the current and future releases.
October 17, 2017 at 2:43 pm #23344
Kent Trammell
Participant
What happens when you try to use the tool – Does it fail to install? Does it give an error when you try to use one of the Sculpt Tools UI operators?
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘I am using v2.78c. I have installed the addon from the link in the notes. I have read the comments below, but I still can …’ is closed to new replies.