Join Now

Found a Solution to the Hole Problem without Decimating

Forum Archive › Found a Solution to the Hole Problem without Decimating

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 10, 2017 at 6:16 pm #6407
    Michael Wanyoike
    Participant

      After creating the second pair and rotating them, I hid the first pair then I pushed the second pair all the way down such that when i did a difference it would cut through till the bottom. Then I unhid first pair and did a union. Then I went into edit mode and removed all double vertices.

      October 10, 2017 at 4:06 pm #25361
      Kent Trammell
      Participant

        Thanks for sharing your solution @brandiqa!

        March 19, 2020 at 9:49 pm #25362
        Marc Andre Fortin
        Participant

          I have found that moving the object slightly before cutting (so the faces don’t overlap) also solves the problem.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘Found a Solution to the Hole Problem without Decimating’ is closed to new replies.