Join Now

12:15 Extruding to thicken the sides

Forum Archive › 12:15 Extruding to thicken the sides

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 12, 2019 at 1:05 pm #8916
    Faith Schnell
    Participant

      12:15 I have watched the video over and over again for thickening the walls of the treasure chest, but no matter what direction I move the mouse, the walls always go out leaving the chopped out corner on each corner.  When I hit the G key after the E key – it is as if I now have two boxes that separate from each other.  I am doing something very wrong.

      August 15, 2019 at 10:45 am #29604
      Kent Trammell
      Participant

        I’m not quite understanding your issue from the description. Could you post a screenshot?

        August 17, 2019 at 10:50 am #29605
        Faith Schnell
        Participant

          I can’t produce a screen print because I can’t do it.  I go to extrude per the video – and the walls protrude out just like in the video.  But then the video has the wall protrude into the cube I can not make that happen, I can only protrude the sides out.

          August 22, 2019 at 2:53 pm #29606
          Kent Trammell
          Participant

            In the video I hit the E (extrude) key and the extruded faces moved up, which is default behavior. However I didn’t want them moved up because technically that’s a second operation following the extrude operation. To negate the second (move up) operation I clicked the Right Mouse Button to cancel it, BUT still keep the extrusion. After right clicking we can use ALT + S to push out or pull in the direction of the face normal which creates the thickness.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • The topic ‘12:15 Extruding to thicken the sides’ is closed to new replies.