Reply To: Collab 2020: Modeling Heavy Equipment (Backhoe)

I could give you something like this:

Which has this horrible topology( so far):

The thing is: you have a blue edge with only one holding edge to control the sharpness turning into a green edge that is supposed to be completely round, so the orange holding edge need to get away from the green edge to make that round if that makes any sense at all;)

The point is that an edge (corner) should have two holding edges, one on each side for full control…

I think you want the green part of the ‘block’ to be round on the top and flat on the side, but if you move the orange edges towrds the green ones, that will make the top flatter..

This is all very hard to explain in words, but I hope you get the drift.