Join Now

Reply To: When making the start of the platform, it’s extruding on X, Y, and Z instead of just X and Y

Forum Archive › When making the start of the platform, it’s extruding on X, Y, and Z instead of just X and Y › Reply To: When making the start of the platform, it’s extruding on X, Y, and Z instead of just X and Y

August 15, 2020 at 12:10 am #59341
silentheart00
Participant

    If you want to make absolutely sure it’s scaling in the axes you want, you can constrain it by Shift + the axis you do not want to scale in, e.g. if I want to scale in XY and not Z, I would press S and then Shift + Z.  It also works for the other transforms, too.