Reply To: Collab 2020: Modeling Heavy Equipment (Backhoe)

Forum Archive Collab 2020: Modeling Heavy Equipment (Backhoe) Reply To: Collab 2020: Modeling Heavy Equipment (Backhoe)

#54392
Shawn Blanch
Participant

    @ketre  Yeah I would say those side consoles on either end of the chair are going to be mostly vertical with a slight curve taper going from fat on bottom to skinny at the top (maybe 15 degrees taper from base towards top from all chair facing sides?). Yeah that whole floor is dead flat. There is no step inside the cab.