Join Now

I followed the tutorial and probably this because i did something wrong… but what is it. and how do i fix it?

Forum Archive › I followed the tutorial and probably this because i did something wrong… but what is it. and how do i fix it?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 12, 2019 at 6:04 pm #8413
    Racso Leon
    Participant

      April 15, 2019 at 12:35 pm #28694
      Racso Leon
      Participant

        I figured it out… i had face normals facing the wrong side… so i had to go to Mesh > Normals > Recalculate Outside  (Shift+N)

        June 24, 2019 at 9:32 am #28695
        Shawn Blanch
        Participant

          This had me tripped up for a while as well until I noticed I could see through a face that was there. I was going to post about this in case someone else got tripped up because it makes the subsurface  modifier do really weird things and almost makes it look like really hard creases with no height change.

          Do yourself a favor and recalculate normals and don’t waste time like I did trying to figure this out. Jonathon talked about it in one of the videos but I thought my modeling skills were better than his (I was wrong LOL)

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘I followed the tutorial and probably this because i did something wrong… but what is it. and how do i fix it?’ is closed to new replies.