How can I make the column in the UV Sphere?

This topic has 1 reply, 2 voices, and was last updated 7 years, 9 months ago by Shawn Blanch.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
November 19, 2018 at 8:30 pm #7950
beatrizl
Participant
I’m scaling up each edge loop after having bevelled the bottom vertex but it feels there should be a better way. I’ve tried extruding too but then I can’t bevel the bottom properly.
December 13, 2018 at 9:40 am #27915
Shawn Blanch
Participant
You can go into edit mode, select the lower 1/4 of the sphere and delete it. Then select the bottom edge and make a face out of it so there is a bottom face. Then you can extrude that bottom down the z axis and it will form a column.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘How can I make the column in the UV Sphere?’ is closed to new replies.