Join Now

What should I do if Blender does not repeat my last used inset/bevel settings? Is there any way to change this in the preferences?

Forum Archive › What should I do if Blender does not repeat my last used inset/bevel settings? Is there any way to change this in the preferences?

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 10, 2018 at 10:19 am #7572
    kevin tan
    Participant
      July 18, 2018 at 12:02 pm #27310
      Jonathan Lampel
      Participant

        Hey Kavern, I found out after recording that it only saves the settings if you tweak them manually after confirming. Try insetting or beveling and then adjust the amount after from the toolbar or F6 menu. That should do it! 

        September 24, 2019 at 3:35 pm #27311
        mavener
        Participant

          @jlampel Does this work in 2.8? Because for me not even the manual tweaing helped.

          September 25, 2019 at 2:45 am #27312
          spikeyxxx
          Participant

            @mavener If you use CTRL-B to bevel, it remembers the number of cuts last used.

            If after confirming the Bevel you change any of the settings in the popup on the bottom left of the 3D view (which you might have to open), or by pressing F9 (used to be F6), it will remember those changes as well. The only thing it doesn’t ‘remember’ is the Width of the Bevel.

            September 25, 2019 at 10:42 am #27313
            mavener
            Participant

              Thanx. Yes it seems it rememebers the segments and profile. But it ignores widht and the checkboxes below.

              September 25, 2019 at 8:21 pm #27314
              Shawn Blanch
              Participant

                Yeah F6 has now been replaced by F9. I keep forgetting that to a point of annoyance.

                Shift+R also repeats the very last action and can also come in handy.

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • The topic ‘What should I do if Blender does not repeat my last used inset/bevel settings? Is there any way to change this in the preferences?’ is closed to new replies.