Going into wire-frame mode when modeling the inside of the mug

This topic has 1 reply, 2 voices, and was last updated 8 years, 2 months ago by Jonathan Lampel.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
June 27, 2018 at 2:23 pm #7536
Dana Williams
Participant
You might what to add an annotation that talks about pressing the z key to go into wire-frame mode.
June 27, 2018 at 3:07 pm #27244
Jonathan Lampel
Participant
Thanks for the note!
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘Going into wire-frame mode when modeling the inside of the mug’ is closed to new replies.