Join Now

Whats the perfect way to make the cube corners “cubic” inset?

Forum Archive › Whats the perfect way to make the cube corners “cubic” inset?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 31, 2017 at 6:31 pm #6389
    koko0
    Participant

      The corners have two modifications:
      1. “triangle inset”, which is trivial to make of you use the vertex bevel.
      2. “cubic inset” and then extrusion. i’ve managed to do it with some bevel and inset uses, but i wonder if there is a better, “intended” way.

      September 5, 2017 at 4:31 pm #25342
      koko0
      Participant

        Then what?
        i can inset the cube in with ctrl:

        then inset another cube:

        then inset it out with ctrl:

        it works, but it’s not accurate (i can’t snap it to match the outer cube).
        it feels weird if i should make an inaccurate thing as an exercise.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • The topic ‘Whats the perfect way to make the cube corners “cubic” inset?’ is closed to new replies.