When creating the quad-arrow custom bone shape I didn't get the same behavior as the course lesson demonstrates in regards…

This topic has 9 replies, 6 voices, and was last updated 7 years, 9 months ago by Ido Reshef.

Viewing 10 posts - 1 through 10 (of 10 total)

Author

Posts
November 15, 2016 at 11:30 am #5738
Mike Padgett
Participant
When creating the quad-arrow custom bone shape I didn’t get the same behavior as the course lesson demonstrates in regards to snapping to the surface of the sphere. The verticies all stayed on the same plane until I enabled “Project individual elements on the surface of other objects” on the right side of the snapping controls. I see it isn’t enabled in the video but you get the behavior anyway so I am curious as to why that is the case.
November 20, 2016 at 9:23 am #24273
jaejunlee
Participant
You saved me! I was suffering from that problem!
Thank you.
November 20, 2016 at 10:12 am #24274
Mike Padgett
Participant
Glad I could help!
November 21, 2016 at 3:08 pm #24275
Kent Trammell
Participant
It appears enabled to me in the video. It would have to be in order to work..
November 21, 2016 at 10:04 pm #24276
Mike Padgett
Participant
Looking over the video again, I see it is enabled but the color scheme makes it hard to tell.
December 16, 2016 at 1:11 am #24277
aboood319
Participant
just one question, where are the snapping controls??? i didn’t find it.
December 16, 2016 at 1:22 am #24278
aboood319
Participant
well i figured it out.;}
it is above the timline.
March 13, 2018 at 4:40 pm #24279
Gatreh Haeggblom
Participant
This wasn’t clear to me so I’ll explain further, Above the timeline you’ll find the vertex, edge and face selection modes, to the right of this you have two options that you skip, then you get to snapping options, in order to be able to snap to surface you have to select Face as the type of element to snap to, and then the option should appear as a ball with a dotted square on the right, then go to forward ortho and press G and left click and it will instantly have snapped into the correct position.
March 14, 2018 at 12:28 pm #24280
Kent Trammell
Participant
Thanks for explaining this clearly @strategicexploits 🙇🏻‍♂️
December 4, 2018 at 8:07 pm #24281
Ido Reshef
Participant
Thank you, Mike !
Author

Posts

Viewing 10 posts - 1 through 10 (of 10 total)

The topic ‘When creating the quad-arrow custom bone shape I didn't get the same behavior as the course lesson demonstrates in regards…’ is closed to new replies.