So, as I use the inflate brush, I notice more faces are being made as you smooth it out, however, when I try to inflate th…

This topic has 3 replies, 3 voices, and was last updated 10 years, 10 months ago by David Penny.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
September 16, 2015 at 2:53 am #5433
josueant007
Participant
So, as I use the inflate brush, I notice more faces are being made as you smooth it out, however, when I try to inflate that boxed like area, new faces don’t get added. I’m so confused. Any suggestions?
September 16, 2015 at 1:21 pm #23855
Kent Trammell
Participant
What is your detail mode set to: Subdivide Collapse, Collapse, or Subdivide Edges?
October 19, 2015 at 5:32 pm #23856
David Penny
Participant
Me too — I have the same problem I believe. I’m using Subdivide Collapse.
October 19, 2015 at 5:38 pm #23857
David Penny
Participant
I’ve discovered the problem. I had enable Dynotop but then, accidentally turned it off again using Undo without realising.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

The topic ‘So, as I use the inflate brush, I notice more faces are being made as you smooth it out, however, when I try to inflate th…’ is closed to new replies.