Very basic question on using the Subdivision Surface Modifier. In the instructional video, for flows and sculpting it sho…

This topic has 3 replies, 3 voices, and was last updated 10 years, 9 months ago by Pete Kazmier.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
September 28, 2015 at 1:52 pm #5386
Christopher Perry
Participant
Very basic question on using the Subdivision Surface Modifier. In the instructional video, for flows and sculpting it shows that a level of 7 can be chosen, but in in my Blender i am limited to an upper selection of 6. Is their an an adjustment I must make in preferences to allow this?
September 29, 2015 at 4:38 pm #23777
Kent Trammell
Participant
The only options I know of for limiting subdivision is in Scene Properties > Simplify. The default there should be set to 6 but that doesn’t mean you still can’t make the modifier above 6. It just won’t display/render above what you set in the Simplify settings.
November 23, 2015 at 2:36 pm #23778
Pete Kazmier
Participant
I seem to have the same limitation as well. I wonder if this is hardware related?
November 24, 2015 at 10:23 am #23779
Pete Kazmier
Participant
I discovered my source of confusion. I cannot use the little arrows to increase beyond 6, but I am able to type in a value of 7. Problem solved!
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

The topic ‘Very basic question on using the Subdivision Surface Modifier. In the instructional video, for flows and sculpting it sho…’ is closed to new replies.