When I try to extrude the basic mesh for the legs, I find that I can only extrude along the y-axis. I tried switching bet…

This topic has 1 reply, 1 voice, and was last updated 9 years, 4 months ago by Morgan Piott.

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 3, 2017 at 12:49 pm #4719
Morgan Piott
Participant
When I try to extrude the basic mesh for the legs, I find that I can only extrude along the y-axis. I tried switching between the other axis but I was unable to freely move the vertices to a place where I could extrude for the legs.
May 5, 2017 at 2:15 pm #22968
Morgan Piott
Participant
Figured it out, I had clipping on.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

The topic ‘When I try to extrude the basic mesh for the legs, I find that I can only extrude along the y-axis. I tried switching bet…’ is closed to new replies.