İnset on the caritidge slot.

This topic has 2 replies, 2 voices, and was last updated 1 year, 4 months ago by Mert Dokuman.

Viewing 3 posts - 1 through 3 (of 3 total)

Author

Posts
May 10, 2025 at 7:57 pm #20167
Mert Dokuman
Participant
Well I was try to Inset Faces, I see two individual faces seperate insert where am I to wrong. I was try a merge vertex it’s not work.
May 11, 2025 at 1:10 am #94953
Martin Bergwerf
Participant
Hi Mert @Mdoku ,

The only thing I can think of, is that you have double Vertices (as you suspected). Go back to before the Inset, Make sure to Select all the Verices between those Faces (Wireframe Mode) and Merge By Distance. Increase the Distance if necessary.
May 11, 2025 at 1:18 am #94954
Mert Dokuman
Participant
Thanx Martin ,

I have some problem on bevel in same area. i think have a to much edge up to up 4 or 5 maybe. I’m not sure is it the problem but I have done one way or other. 🙂
Author

Posts

Viewing 3 posts - 1 through 3 (of 3 total)

The topic ‘İnset on the caritidge slot.’ is closed to new replies.