Join Now

Surprise Challenge

Forum Archive › Surprise Challenge

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 20, 2025 at 2:37 pm #20062
    Gerard van den Brul
    Participant

      This is my result of the week challenge by modelling something from the kitchen. I choose to model a garlic press.

      I started out by examining the piece and created some reference photos for accurate dimensions. I did this before the actual modelling.

      The modelling process did cost me 60 minutes and I had to take some shortcuts when it came to topology. Otherwise, I would have certainly not made it within the 60 minutes. After the modelling I gave it some material, put in a 3-point light and a floor surface. Took me about 30 minutes for the final renders.

      Original.png

      Garlic Press 01.png

      Garlic Press 02.png

      Garlic Press 04.png

      Garlic Press 03.png

      April 20, 2025 at 6:43 pm #94562
      Omar Domenech
      Participant

        There’s garlic pressers? All I can say is, thank god for Capitalism. It’s looking great. I think the only feedback is the resolution of the round shapes, I can see the stepping due to low geometry. Nothing an extra level on the SubD can’t handle. 

        April 21, 2025 at 4:04 pm #94563
        Gerard van den Brul
        Participant

          Thanks for the feedback. I also noticed the lack of resolution when rendering up close, but I ran out of time so left it as is to keep to the assignment. I will change garlic pressers. 🙂

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘Surprise Challenge’ is closed to new replies.