Join Now

Chap. 5 Using Hot Key F9 – or Shift Ctrl Z, Doesn’t Work with 4.0!

Forum Archive › Chap. 5 Using Hot Key F9 – or Shift Ctrl Z, Doesn’t Work with 4.0!

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 23, 2024 at 4:22 pm #17586
    Patty Hatfield
    Participant

      Time 6;47 – After selecting a plane, I find my mmb works to magnify the plane, but it doesn’t actually enlarge or change its size. I attempted this because F9 is not active. There is no redo panel either, or I can’t see it at lower left bottom of screen.
      When I go to Edit, scroll down , I do not see F9 only see an inactive Shift Crtl Z which neither of them work.
      What am I missing? I do remember I was never able to get F9 or F2 to work several years ago when I was using 3.1 – Please explain.

      February 23, 2024 at 4:53 pm #84493
      Patty Hatfield
      Participant

        Oh…..I remember! the redo Plane only appears right after you add an object, but as soon as you click on the screen , the redo panel disappears. However…  pressing Shift Ctrl Z at same time brings up  four ways to view object: wire, solid, material, rendered.  But  does not activate hot key F9 to change size!  has this changed within 4.0?

        February 23, 2024 at 7:25 pm #84494
        Patty Hatfield
        Participant

          Regarding my original post:  Since the F9 disappears once I touch something else on the page or window…. if I do needed to change the properties later, I can always use the Tool Bar or go to Object  Properties and use the transform section! However, the F9 and/or F2 key doesn’t works. Is there a reason?

          February 23, 2024 at 7:57 pm #84495
          Patty Hatfield
          Participant

            ONE LAST Observation: I just found my mistake. I have been pressing the F key, then the 7 key….. I didn’t see the ‘F9′ and F2’ keys on the top of the keyboard.. The keyboard has a shadow casting  over the F key  section……so sorry everyone. 

            February 24, 2024 at 12:53 am #84496
            Martin Bergwerf
            Participant

              Just to be clear,

              You understand everything now, right?

              February 24, 2024 at 12:13 pm #84497
              Omar Domenech
              Participant

                There’s an updated Blender Basics course for Blender 4.0, link below:

                https://cgcookie.com/courses/blender-basics-an-introduction-to-blender-4-x

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • The topic ‘Chap. 5 Using Hot Key F9 – or Shift Ctrl Z, Doesn’t Work with 4.0!’ is closed to new replies.