Join Now

Loop Cut Crossing NGons in 3.4?

Forum Archive › Loop Cut Crossing NGons in 3.4?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 12, 2023 at 6:16 pm #15969
    Alex S
    Participant

      I was following along with this video and when I got to the last operation where Jonathan is demonstrating that loop cuts stop at triangles and ngons, the triangle by the ear did stop the loop cut but, when I made the ngon on top of the head, the loop cut looks like it will stop in the preview but connects across once confirmed.

      Loop cut preview

      Loop cut confirmed

      I’m not sure what version of Blender this was done on, I’m on 3.4, so maybe it’s different now?

      February 13, 2023 at 7:41 am #77685
      Omar Domenech
      Participant

        Ah yes, Blender does that now for you. If it sees that the loop will stop but it’s just one or two steps of being connected, it will automatically connect the loops for you. It’s a good addition, that behavior saves a step or two, but sometimes causes the opposite effect since maybe what you are looking for is for the loop to stop and Blender comes and connects then and you’re like dangs, now I have to manually disconnect them.

        March 14, 2023 at 12:43 pm #77686
        gmw
        Participant

          Nice catch Alex!

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘Loop Cut Crossing NGons in 3.4?’ is closed to new replies.