Dyno got turned off but I didn’t notice it

This topic has 3 replies, 3 voices, and was last updated 4 years, 3 months ago by gailgongster.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
June 5, 2022 at 8:43 pm #15189
gailgongster
Participant
Kent turned Dyntopo on before he Snake Hooks the ear out. I think at time 3:29, the Dyntopo checkmark gets unchecked but Kent didn’t mention that he turned it off. Should I turn my Dyntopo off after Snake Hooking the ear?
June 6, 2022 at 4:20 am #74473
Sébastien Lenaerts
Participant
Removing my answer as I assumed the wrong thing … sorry about that and thanks @adrian2301 for the why behind this mistery 🙂
June 6, 2022 at 9:03 am #74474
Adrian Bellworthy
Participant
@gailgongster, the course took Kent the best part of 2 years to complete. Because of this he uses an earlier version of Blender.

I believe up until recently Dyntopo would turn itself off when exiting and re-entering sculpt mode.

I would suggest you leave it on.
June 6, 2022 at 10:21 am #74475
gailgongster
Participant
Thank you @slenaerts for having a look, and thank you @adrian2301 for you quick response. I’ve adopted the mindset to slowly go through these lessons and repeat as often as I feel I need to understand. When I found that I had missed Kent’s blender turning Dyntopo off, I went back to where I was at the beginning of this lesson and redid, turning Dyntopo off after sculpting the ears. I will go back and try leaving Dyntopo on and see how it goes. Thank you again.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

The topic ‘Dyno got turned off but I didn’t notice it’ is closed to new replies.