Join Now

In making of columnn where cube and cylinder need to be single mesh

Forum Archive › In making of columnn where cube and cylinder need to be single mesh

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 6, 2022 at 1:27 am #15020
    muskan joshi
    Participant

      I couldn’t able to connect the two vertices in making of columnn where cube and cylinder need to be single mesh by selecting one vertices from cube and other from cylinder and connect with command F 

      April 6, 2022 at 2:32 am #73983
      spikeyxxx
      Participant

        @chittu a bit of guesswork, but are your Cube and Cylinder one Object?

        Because in a situation like this:

        F.png

        you will not be able to connect the two.

        If that is the case, you can, in Object Mode select both and then press CTRL+J to make them into one Object.

        April 6, 2022 at 2:37 am #73984
        spikeyxxx
        Participant

          Oh, and when that was what happened, you should select everything in Edit Mode and run the M > Merge by Distance command, because you probably, by trying to Fill,  made some extra Vertices on top of the others and that will cause problems!

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • The topic ‘In making of columnn where cube and cylinder need to be single mesh’ is closed to new replies.