need to change the topology for texturing.

This topic has 4 replies, 2 voices, and was last updated 5 years, 5 months ago by yukino hatake.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
April 2, 2021 at 10:22 am #13701
yukino hatake
Participant
Hello guys,

what is the most easy way to fix this?

i first removed them, but now i realized i do needed it . i cant undo it anymore so i wonder what the most efficient way would be to do this
April 2, 2021 at 12:23 pm #64657
Jonathan Lampel
Participant
You could use the knife tool to make those cuts and then dissolve the other edges.
April 2, 2021 at 2:05 pm #64658
yukino hatake
Participant
With the knife tool can i say go a straight line in the z direction, so its parallel to the rest?
April 2, 2021 at 3:06 pm #64659
Jonathan Lampel
Participant
Sure, hit C (I think, double check the status bar for hotkeys) to constrain it to an angle.
April 3, 2021 at 11:32 am #64660
yukino hatake
Participant
@jlampel , Thanks a lot it worked 🙂 needed a minute to figure it out but it saves lots of time 😀
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

The topic ‘need to change the topology for texturing.’ is closed to new replies.